Something to say,
you will never be lost for words


Last issue we had
Curses, Wisdoms and Quotes.
Well here are a few collected since then...



Quotes

"You can't have everybody handling your stick."

"Alert the media"

"1,000 undergraduates, 100 academic staff, 200 ancillary staff,... half a nun"

"I went home with someone and it was on his wall"

"Who is Mr. Reshanhi and why is he sitting in my linen press"

Widsoms

"Paper clips come with a 30 day guarantee"

"Read and Heed all labels"


Disinformation

"This department requires no physical fitness program, everyone gets enough exercise jumping to conclusions, flying off the handle, running down the boss, knifing friends in the back dodging responsibility and pushing their luck."




(as explained to a foreigner)

You have two sides,
one out in the field and one in.

Each man that's in the side that's in goes out
and when he's out he comes in
and the next man goes in until he's out.

When they are all out the side that's out comes in
and the side that's been in goes out
and tries to get those coming in out.

Sometimes you get men still in and not out.
When both sides have been in and out including the not outs
That's the End of the Game.

Howzat!





  1. All pipe is to be made of a long hole surrounded by metal or plastic centred around the hole.
  2. All pipe is to be hollow throughout the entire length, do not use holes of different length than the pipe.
  3. The I.D. (Inside Diameter) of all pipe must not exceed the OD. (Outside Diameter)-otherwise the hole will be on the outside.
  4. All pipe is to supplied with nothing in the hole so that water, steam or other stuff can be put inside at a later date.
  5. All pipe should be supplied without rust, this can be more readily applied at the job site. Note: Some vendors are now able to supply pre-rusted pipe. If available in your area, this product is recommended as it will save a great deal of time on the job.
  6. All pipe over 500ft f (153m) in length should have the words (Long Pipe) clearly painted on each end so the contractor will know it is a long pipe.
  7. Pipe over 2 miles (3.2km) in length must also have the words (Long Pipe) painted in the middle so the contractor will not have to walk the entire length of the pipe to determine whether or not it is a long pipe or a short pipe.
  8. All pipe over 6 inches (125mm) in diameter must have the words (Large Pipe) painted on it so the contractor will not mistake it for a small pipe.
  9. Flanges must be used on all pipe. Flanges must holes for bolts quite separate from the big hole in the middle.
  10. When ordering 90 degree, 45 degree, or 30 degree elbows, be sure to specify right hand of left hand otherwise you will end up going the wrong way.
  11. Be sure to specify to your vendor whether you want level, uphill or downhill pipe. If you use downhill pipe for going uphill, the water will flow the wrong way.
  12. All couplings should have either right hand or left hand threads, but do not mix the threads; otherwise as the coupling is being screwed on one pipe it is unscrewing from the other.